| GBP31.09 |
WEBSITE HERE
http://shrsl.com/?~5rgh
Details:
- 510 threaded connector
- Variable Wattage from 7W-20W in .1 watt increment
- Body is made of aluminum
- OLED display shows battery charge state, volts and ohms
- Micro-USB charging port
- Built in 1500mah Lithium Polymer battery
- Locked mode: Pressing the fire button five times with less than .7 seconds between presses will cause the device to enter "Locked mode". In Locked mode, the device will not fire and the output power will not adjust accidentally. While in Locked mode, the screen will be off, except that pressing a button will show “Locked, click 5X”. To exit Locked mode, press the fire button 5 times
- Stealth mode: While locked, pressing the fire and down buttons simultaneously for five seconds will switch to stealth mode. In this mode the display is off. It will still show error messages and the “Locked, Click 5X” advisory. To switch back to normal display mode, from locked mode hold down the fire and down buttons simultaneously for 5 seconds. This setting is stored to internal flash memory, and remains if power is removed
- Right Mode and Left Mode: While locked, holding the fire and up buttons simultaneously for 5 seconds flips the display. This setting is stored to internal flash memory, and remains if power is removed
- Error Messages: The DNA 20 will indicate a variety of error states
- Check Atomizer: The DNA does not detect an atomizer, or the atomizer has shorted out
- Shorted: The atomizer or wiring are short circuited
- Check Battery: The battery is below 3.1 volts. It probably needs to be charged
- Weak Battery: The battery sags excessively when firing. This typically means the user is not using a high rate battery, or the battery is old and degraded. It can also mean the battery is not making good contact
- Too Hot: The DNA 20D has onboard temperature sensing. It will shut down and display this message if the internal board temperature becomes excessive
- Too low power setting: The DNA 20D puts out a minimum of 4 volts. With low power settings (7 to 8 watts) and low resistance atomizers (below 2 ohms) the DNA will sometimes be unable to provide a low enough power output to be power regulating. If this is the case, the Ohms display will be flashing. The device will still operate.
- Auto power down: The screen will be at full brightness while firing. After 15 seconds with no button presses, the screen will dim. 4 minutes after the last button press, the screen will fade out and the device will go to sleep mode. Pressing any button will turn the device and display back on
